TIPS XV: JUMP RULES
'Jump' is a parameter that displays jumping power. The 'Jump' value shows how high (h) you can jump. Also you can jump over a gap which is half the distance of the 'Jump' value.
However, when jumping horizontally, the height of the panel edge to jump off (not the height of the panel) must be the same height or higher than the panel edge you're landing on. So, if the height is 4.5h and the panel you jump off has a slope of 1h (the panel edge is 4h), you can jump to the next panel which is 4h. However when the height is 4.5h, you can't jump over a gap on a panel with an edge height of 5h. You must jump down to the bottom of the gap and then jump vertically up to the panel. The movable range is determined by the 'Jump' rules like those mentioned above, in addition to other rules.
However, when jumping horizontally, the height of the panel edge to jump off (not the height of the panel) must be the same height or higher than the panel edge you're landing on. So, if the height is 4.5h and the panel you jump off has a slope of 1h (the panel edge is 4h), you can jump to the next panel which is 4h. However when the height is 4.5h, you can't jump over a gap on a panel with an edge height of 5h. You must jump down to the bottom of the gap and then jump vertically up to the panel. The movable range is determined by the 'Jump' rules like those mentioned above, in addition to other rules.
PREV
|
NEXT
BACK